ABB Welcome M25102 C Series

To Next Page

To Previous Page

ABB Welcome

— 10 —

Change default lock

Default lock can be set at either "Lock-GND" or "NO-NC-COM"

Set outdoor station address ="0"

Short circuit the "Exit" two terminals for 3 seconds to enter the

setting mode

(3 LED flashes green to show the setting mode for aluminum outdoor

station)

(prompt tone “di” for stainless outdoor station)

Tones for indication:

Lock 1 (LOCK-GND) = default lock

Lock 2 (NC-NO-COM) = default lock

Short circuit “Exit” terminal on outdoor station to switch the default lock

30 seconds time available to save the setting and exit the

programming mode

ABB Welcome M25102 C Series - Page 10