ABB Welcome
®
Set the lock time of the default lock
Set the time by the potentiometer, from 1-10 seconds
Set the lock time of the second lock
Set outdoor station address ="0"
Short circuit the “DS” two terminals for 3 seconds to enter the
setting mode
(3 LED flashes green to show the setting mode for aluminum outdoor
station)
(Beep tone sounds for stainless outdoor station)
Record the time for first lock
Then set the time for second-Lock from 1-10 seconds
30 seconds time available to save the setting and exit the
programming mode
At last set the time back for 1st-Lock
Reset the time to the original time for first lock
To Next Page
Loading...
