ABB Welcome M25102 C Series - Keypad Outdoor Station Without Display (Camera + Audio + Keypad); Calling a Resident by Inputting Physical Address; Call Guard Unit; System Settings

ABB Welcome
®
— 56 —
5.6 Keypad outdoor station without display (camera + audio + keypad)
5.6.1 Calling a resident by inputting physical address
In standby mode, a visitor can enter the physical
address corresponding to the residence to call
directly, from 001 to 250.
For a complex building, the visitor needs to press the
building number (01-60) plus physical address (001-
250) to make a call from a gate station.
5.6.2 Call guard unit
Press the button to make a call to a guard unit.
5.6.3 System settings
Users can enter the system settings by following these steps. (In settings, press “#” to confirm, press “*” to cancel. The default system
password is 345678.)
1. Set the device as an outdoor station or a gate station.
Outdoor station:
#* system password # =>
1 # => 1 #
Gate station:
#* system password # =>
1 # => 2 #
2. Modify the "system password"
#* system password # =>
2 # => Enter new password (6-8 digits) # => Enter the password again #
3. Modify the "door open code"
#* system password # =>
3# => Enter new door open code (3-8 digits) # => Enter the code again #
4. Setting the voice message
If you are using the audio module with speech synthesis function (M251024A-.),
the local language can be set.
#* system password # =>
4# => Press or to choose the language => #
5. Enable or disable the access control function
Enable access control function:
#* system password # =>
5# => 1 #
Disable access control function:
#* system password # =>
5# => 2 #