20
If desired; the console could be pre-programmed to :
• Count down from a specific time (if none is indicated, the computer
will count up from 0)
• Count down from a specific number of strokes (if none is indicated, the
computer will count up from 0)
• Count down from a specific distance (if none is indicated, the computer will
count up from 0)
• Count down from a specific number of calories burned (if none is indicated, the
computer will count up from 0)
How to pre-set:
To pre-set the computer, use the MODE button to choose the function you want to
program. When the desired function is flashing, use the arrow-keys to select the
desired value.
By pressing MODE again, the computer will switch to the next function
Once you have pre-set any value, start at any time.
The computer will stop when either of the pre-set values reach 0.
Possible settings
TIME From 00:00 to 99:00. Each step comes to 1:00 minute
COUNT From 0 to 999. Each step comes to 1 stroke
DISTANCE From 0,00 to 99,99. Each step comes to 0,1 km
CALORIE From 0 to 990. Each step comes to 10 kcal
Reset program:
Press RESET to reset all the values registered during workout.
Enter each function and adjust to zero, for all pre-set values.
Symbols
This symbol will indicate the length of each stroke
If the console has not been used for 4 minutes, the display will automatically shut
down to save energy. To re-start, push one of the buttons or start rowing.
If the information in the screen becomes weak or blurry, replace batteries with fresh
ones.
The computer runs on 4 pcs. 1,5V AA batteries
All information in the computer will be erased with each change of batteries.
To Next Page
Loading...
