16
easily, you have found the problem.
Do not put grease on the outside of the pulley where the cables go. The cable should rotate the pulley
when moving. Do not slide the cable. Remove the pulley from the machine. The wheel on the pulley
rotates around a small shaft (usually a bolt) with a bearing around it. Check that nothing is stuck between
the shaft and the pulley. Dirt can build up over time and prevent the pulley from moving properly.
The bearing may be dirty. If the bearing does not rotate evenly, the pulley will not. Check if your pulley
moves smoothly after thorough cleaning. Is the warehouse rolling properly? If it does, put it back on.
If it does not, it is worth trying to lubricate the bearing if the pulley has a ball or roller bearing. If it is still
good, lubrication of the bearing can solve your problem. Do not use oil to lubricate bearings or roller
bearings. It is better to use fat since it stays in place and lasts longer.
If you have tried to lubricate the bearing and it still does not work correctly, it is best to simply replace the
entire pulley.
IMPORTANT REGARDING SERVICE
In the event of problems of any kind, please contact Mylna Service. We would like you to contact us before
contacting the store so we can offer you the best possible help.
Visit our website www.mylnasport.com - here you will find information about the products, user manuals, a
contact form to get in touch with us and possibility to order spare parts. By filling out the contact form you
give us the information we need to help you as effectively as possible.