To Next PageTo Next PageWhat to do if the ABON Ultra S light is flashing?
If the light on your ABON Garage Door Opener flashes, it usually means the door has encountered an obstruction. To resolve this, perform a performance test.
Why does my ABON Garage Door Opener stop halfway?
If your ABON Garage Door Opener switches off during motion, this could be due to a problem with the door's function or the entrapment protection system. Program the door operator and then reset it.
What to do if the ABON Ultra S Garage Door Opener safety sensor is not working?
If the safety device on your ABON Garage Door Opener isn't working, it might be due to an incorrect setting of the door or entrapment protection system. Reset and reprogram the system.
General| Brand | ABON |
|---|---|
| Model | Ultra S |
| Category | Garage Door Opener |
| Language | English |
Defines the intended use of the garage door drive for private sector use only.
Lists prohibited uses, such as commercial or industrial applications.
Highlights working or operating procedures that must be observed to avoid danger to persons.
Provides information that must be observed to prevent damage to the device.
Indicates technical requirements that have to be particularly observed.
Lists and describes control and display elements like buttons and LEDs.
Lists and describes external connection points for safety devices and antennas.
Instructions for unpacking and connecting the hand-held transmitter and antenna.
Steps to connect the drive to the mains power supply and initial checks.
Procedure for learning end positions and forces using the hand-held transmitter.
Steps to confirm the learned "UP" end position and subsequent automatic door movement.
Methods to confirm the learned "DOWN" end position and subsequent automatic door movement.
Confirms the learned force for the "UP" direction and initiates automatic closing.
Procedure to set the "UP" end position without a transmitter, involving physical button presses.
Confirms the "UP" end position and initiates automatic closing using the program button.
Procedure to set the "DOWN" end position without a transmitter, involving physical button presses.
Procedure to learn and confirm the force for the "UP" direction without a transmitter.
Procedure to learn and confirm the force for the "DOWN" direction automatically.
Details on how to test the obstruction safeguard's functionality by applying resistance.
Instructs users on safe operation and highlights risks of crushing or cutting.
Advises keeping transmitters away from children and observing door movement.
Procedure to learn new or additional transmitter buttons to the drive.
Lists terminals for connecting additional devices like lamps, antennas, and earth.
Procedure to enable or disable the soft run function for closing direction.
Procedure to enable or disable the pre-warning time for the drive lamp.
Details on setting automatic closure, requiring additional safety equipment.
Instructions for connecting additional illumination, requiring a qualified electrician.
Instructions for connecting emergency stop equipment to the drive.
Instructions for connecting safety strips, optical sensors, or light barriers.
Explains self-test procedures and how flashing green LED signals malfunctions.
Troubleshooting steps for when the drive fails to operate.
Troubleshooting common drive faults, including sled issues and belt adjustment.
Troubleshooting steps for issues with hand-held transmitter operation.
Troubleshooting for the wall-fitted button and its control lead.
Procedure to reset the control and carry out basic settings if obstruction safeguard fails.
Tasks to perform monthly, including checking safeguards and mountings.
Tasks to perform yearly, including greasing joints and checking drive belt tension.
Step-by-step guide for replacing the battery in the hand-held transmitter.
Instructions for replacing the glow lamp, including disconnecting power.
Procedure for replacing the fuse, including disconnections and fuse value observation.
Instructions for resetting the electronic control and performing new learning runs.
