12
10) Next, insert the push buttons (PWR, Vol-, VOL+, SEEK- & SEEK+) onto the board and solder
them from the bottom side.
11) Insert the 3.5mm audio socket (PHONE) onto the board and solder the pins that are
inserted in the square-shaped pads. There are five of them.
12) Finally, place the single-row 4-pin header (ASW) on the board and solder it from the
bottom side. Remember that the longer leads should be on the top as seen in the picture.
13) Your circuit board should look like this if you have proceeded up to step 12.
To Next Page
Loading...