Absco Industries Assembly Instruction Manual
ABSCO SIGNATURE PATIO
MODEL: ADPATIO3030
3.11m W x 3.11m D x up to 3.18m H
Model: ADPATIO3030
21/09/23 1.0
1
AU: 1800 029 701
N Z: 0800 466 444
admin@absco.com.au
www.abscosheds.com.au
Trim posts to suit
existing structure.
2862 mm
2985 mm
3115 mm
3110 mm
3180 mm
MAX
For construction in non-cyclonic areas
Wind rating: N3 as per AS4055-2021.
If you require a higher wind rating please contact
us: admin@absco.com.au or 1800 029 701
NOTE 1 - A good building knowledge is required
to complete this structure.
If you are not capable it is recommended you hire
a professional.
NOTE 2 - The existing structure should be
checked for its capacity to support and tie down
this structure prior to construction by a suitably
qualified engineer.
NOTE 3 - The existing structure is assumed to
be stable in its own right and capable of carrying
the loads imposed by this structure. This must be
checked by a suitably qualified person prior to
construction.
NOTE 4 - Concrete slab must be a minimum of
100mm thick, 20 MPa concrete reinforced with
SL72 mesh and extend for the full area covered by
the structure.
To Next Page
Need help?
General