Step 3: the left and right beams are connected.
Step 4: M8x30 bolts fix the vertical beam to the beam. Secure the beam to the wall connector and
use a T-bolt M6x16 and a hex nut.
Install the upper and lower slot joints, a total
of 3, use the 3mm hex wrench to screw in,
the front side does not install the slot
connector, because the front may need to
put the T-nut to fix the hanging plate.
Note: There is a tapping on one end of the
beam, and the tapping end cannot be placed
in the middle. Placement in the middle will
result in the vertical beam not being fixed.
Cylindrical head
hexagon bolts M8x30
fixed
T-bolt M6x16 and nut
fixed beam.
To Next Page
Loading...
