- 14 -
11.Click “Screen Connection”
8.If only one USB or one serial port connecting computer to Nova controller system, the used serial port will
be automatically set as the current serial port. Otherwise, if multiple USB or serial ports are used to connect
control systems to the computer, the serial port that is used to connect the control system which is to be
configured should be set as the current serial port.
9.Click “Next”>“Screen Config-Com?”Click “Sending Board”, make sure the data of the sending card and the
computer video card are the same. Reset the data if their data are not the same. As shown in following
figure. Normally, default data is correct, no need re-set up.
10.Click “Save” after confirm the data Switch to the Scan Board page as bellowing figure, load file > Send To
HW > Save
Leading LED Applications
K series
User Manual
To Next Page
Loading...
