What to do if the Absima ADB 1.4 Motorized Toy Car motor suddenly stops?
If the Absima Motorized Toy Car suddenly stops, it may be due to a lost throttle signal or activation of low voltage/overheat protection. Check the transmitter, receiver, and throttle wire connections. Consider replacing the battery pack or cooling down the ESC.
Why my Absima Motorized Toy Car cannot get to top speed?
If your Absima Motorized Toy Car isn't reaching top speed and the red LED isn't solid at full throttle, incorrect transmitter settings may be the cause. Check and set D/R, EPA, and ATL to 100%, or turn the knobs to the maximum value. Also, set TRIM to 0 or turn the knob to its neutral position.
What to do if Absima Motorized Toy Car motor doesn't work after power on?
If the Absima Motorized Toy Car's motor doesn't work, emits no sound, and the LED is off after powering on, the ESC might not be getting voltage, or the connections between the battery pack and ESC are broken. Check the battery wire connections and replace any defective connectors.
Why Absima Motorized Toy Car motor doesn't work but the LED does?
If the LED in the ESC of your Absima Motorized Toy Car works but the motor doesn't, the connections between the motor and ESC might be broken, or the motor itself could be damaged. Check the connections and replace any defective connectors. If necessary, replace the motor.
Why Absima Motorized Toy Car motor doesn't work and red LED blinks?
If the Absima Motorized Toy Car motor doesn't work and the red LED blinks after powering it on, the throttle signal may be abnormal. Check the throttle wire connection and ensure it's properly plugged into the throttle channel of the receiver.
What to do if my Absima ADB 1.4 can't go backward?
If the Absima Motorized Toy Car can't go backward, the jumper position might be incorrect, or the neutral point of the throttle channel has changed. Check the jumper and plug it into the correct position. Set the 'TRIM' of the throttle channel to 0 or turn the knob to its neutral position.
Why is my Absima Motorized Toy Car motor cogging?
If the motor is cogging when you quickly accelerate your Absima Motorized Toy Car, it might be due to the battery's limited discharge ability or an issue in the car's driving system. Try using a battery with better discharge ability. Consider using a motor with lower RPM or a smaller pinion for a softer gear ratio. Also, inspect the car's driving system.
How to fix Absima ADB 1.4 Motorized Toy Car running backward?
If your Absima Motorized Toy Car runs backward when you give it throttle, the wire connections between the ESC and the motor need to be changed. Swap two wire connections between the ESC and the motor.
Why Absima ADB 1.4 can't go forward but can go backward?
If the Absima Motorized Toy Car can't go forward but can go backward, the direction of the throttle channel is likely incorrect. Reset the direction of the throttle channel from 'NOR' to 'REV', or from 'REV' to 'NOR'.
Warning that the product is not a toy and unsuitable for children under 14.
Checks and preparations required before operating the model car.
Recommended checks and maintenance after each use of the model car.
Instructions on how to adjust the motor pinion and main gear distance.
Declaration that the product complies with EU directives.
Steps to follow for preparing the RC car before driving.
Additional important points to consider during operation.
Essential service tasks to perform before and after each use for safety.
Disclaimer regarding liability for damages from product use or misuse.
Manufacturer's declaration of product compliance with EU directives.
Guidelines for the proper disposal of electronic waste and batteries.
Emphasizes the product is not a toy and requires caution.
Checks and preparations required before operating the RC car.
Recommended checks and maintenance after each use of the RC car.
How to set the correct distance between motor pinion and main gear.
Statement of product compliance with EU directives.
Initial steps and setup for operating the RC car.
Important operational considerations and warnings for RC car use.
Essential maintenance and checks before first and subsequent uses.
Absima GmbH's limitation of liability for product use and operation.
Statement of product compliance with EU directives.
Proper disposal procedures for electronic equipment and batteries.
Instructions for installing batteries in the transmitter.
Setup procedure for the fail-safe function.
Technical specifications for the electronic speed controller.
Initial setup and connection guide for the ESC.
Low voltage cut-off protection details for a specific ESC model.
Low voltage cut-off details for a specific ESC model variant.
Comparison of features between two ESC models.
Statement of product compliance with EU directives.
Key features of the waterproof sensorless brushless speed controller.
Technical details of the waterproof sensorless brushless speed controller.
Instructions for connecting and starting the new ESC.
Statement of warranty and liability for the ESC.
General| Scale | 1/10 |
|---|---|
| Type | Buggy |
| Drive | 4WD |
| Wheelbase | 285mm |
| Chassis Material | Plastic |
| Suspension | Independent |
| Radio System | 2.4GHz |
To Next Page
