12
Jumper: Alarm on Dry
When this jumper is attached, the detector
reacts when it is no longer in contact with
water (i.e it reacts to dry surroundings
instead of contact with water).
Jumper: Super Disable
No supervision messages are sent to the
alarm centre when this jumper is attached.
This results in a longer battery service life.
Ensure that supervision is deactivated on
the alarm centre before setting this jumper.
Learning
1. Set the Secvest wireless alarm system
to learning mode. Consult the
instructions of the alarm centre for more
details.
2. Activate the tamper contact of the water
detector to send a tamper message to
the wireless alarm system. The alarm
centre acknowledges the detector with a
double tone. After learning, the detector
must be assigned the “Technical alarm”
zone type.
3. Make sure that the detector is
recognised by your wireless alarm
centre, then close the detector.
To Next Page
Loading...
Need help?
General
