Abus FUBW50020 - Note on Perimeter Warning (Secvest 2 WAY); Configuration

32
Note on the perimeter warning (Secvest 2WAY)
Use the “perimeter warning” as the zone type – for more details refer to the instructions for
the “Secvest 2WAY” alarm panel.
Configuration
You can set several configurations on the detector – see the programming table. The
default settings are shaded. Changes can be easily made. To restore the default settings,
switch off the power supply to the detector; then hold down the program button [Fig. 9] and
connect the power supply again (insert battery).
Programming table
Options
1
Range in m
10
20
30
2
Pulse counter*
1
2
*PULSE COUNTER
Number of events which both sensors must detect before an output occurs.