20
Training
1. Set the wireless alarm centre /
wireless receiver to learning mode.
See the receiver instructions for more
details.
2. Wireless variation:
Activate the tamper contact on the
wireless vibration detector to send a
tamper message to the wireless alarm
system.
IR variation:
Point the LED of the vibration detector at
the IR receiver of the wireless extension
(RFX). Trigger a tamper contact on the
detector.
3. Make sure that the vibration detector is
recognised by your wireless alarm
system / wireless receiver, then close
the housing.
Settings
The vibration detector has a variety of
possible settings that are made using the
jumpers.
To Next Page
Loading...
