To Next Page

To Previous Page

FAQ

- The drive cannot be programmed, there is no acknowledgement tone

==> drive plate on back of housing is not set correctly (go to 4.2f)

- It is not possible to move to zero position (handle in closed position)

==>Adjusteaseofoperationofthedoor,xingscrewsmaybetootightloosenslightly,optimise

mechanicaltting

- The wireless remote control or wireless keypad in combination with another HomeTec Pro door or

window drive are not working properly

==> Program the 1st drive with a single click and the 2nd drive with a double click on the wireless

remote control (see CFF3000 wireless remote control manual)

==> Program the drives separately on the keypad (drive 1, drive 2, drive 3) (see CFT3000 wireless

keypad manual)

- When opening the window / patio door from its tilt position, and it falls out of its anchoring

==> Deactivate tilt function or support door during motorised movement (go to 7, menu level 2,

Setting tilt function)

- During the motorised movement, a warning signal sounds, the drive jams and the window handle

alsostopsinanundenedposition(overloadofthedrive)

==> Check ease of movement of the window / patio door and adjust as necessary

==> Increase drive torque if necessary (go to 7, menu level 2, Setting torque)

-Ashortbeepsoundsvetimesbeforemotorisedmovementorwhenpressinginthepressurecylinder

==> “Low batt” message, replace all batteries with new alkaline batteries or fully charged “ready-to-

use” batteries (go to 4.4)

-Asustainedbeepsoundsvetimesaermotorisedmovementorwhenpressinginthepressure

cylinder

==> An attempt at burglary has likely taken place. Please check your window for possible evidences

of a forced entry and, if need be, inform the police.

-Whenthecylinderispushedin,andthereisnoacknowledgementtoneaer2seconds

==> The window handle is not in closed position

==> Check the magnet position (go to 8)

- The handle cannot be operated mechanically

==> Cylinder pushed in, unlock with key

- When the pressure cylinder is pushed in in closed position and the acknowledgement tone sounds,

it is followed by the alarm tone

==> Glass breakage sensor is defective or incorrectly connected (go to GBM, page 57)

==> Wire bridge accidentally removed without connection of a glass breakage sensor (go to GBM,

page 57)

Abus HomeTec Pro FCA3000 User Manual

Questions and Answers: