Need help?Do you have a question about the AC 25-1 and is the answer not in the manual?
Study all instructions before operating. Avoid overloading and use on stable surfaces.
Lift on specified points only. Support vehicle with stands immediately. No personnel under load.
Max 2 extensions, no alterations. Max air pressure 10 bar/145 psi. Non-compliance causes damage.
Turn jack upside down for handle mounting. Twist hoses around tube as shown (Fig. 1).
Warning: Do not operate on side. Lubricate parts before use. Check air connection and capacity.
Store standing. Lying may cause spillage. Adjust handle to 4 positions.
Press top button to lift, bottom button to lower. Lower completely to protect cylinder.
Qualified personnel only. Lubricate air motor daily. Monthly tasks include separator check and part lubrication.
Refill oil via hole (8). Use ISO VG 15 hydraulic oil. Never use brake fluid! Inspect for damage.
Inspect for damages, wear, valve adjustment, leaks. Ensure safety labels are legible.
Jack not lifting: check oil. Motor slow/stops: check air filter.
Load dropping: change valve cores. Cylinder leaks: change seals. Check for handling errors.
Replace worn/broken parts with genuine manufacturer parts only.
Oil must be drained off and legally disposed of.
Diagram illustrating the hydraulic system of the jack.
Details and part numbers for optional saddles and extensions for the jack.
Special extension may not be used with other extensions.
Statement of conformity with EC Machinery Directive 2006/42/EC and related regulations.
Study all instructions before operating. Avoid overloading and use on stable surfaces.
Lift on specified points only. Support vehicle with stands immediately. No personnel under load.
Max 2 extensions, no alterations. Max air pressure 10 bar/145 psi. Non-compliance causes damage.
Turn jack upside down for handle mounting. Twist hoses around tube as shown (Fig. 1).
Warning: Do not operate on side. Lubricate parts before use. Check air connection and capacity.
Store standing. Lying may cause spillage. Adjust handle to 4 positions.
Press top button to lift, bottom button to lower. Lower completely to protect cylinder.
Qualified personnel only. Lubricate air motor daily. Monthly tasks include separator check and part lubrication.
Refill oil via hole (8). Use ISO VG 15 hydraulic oil. Never use brake fluid! Inspect for damage.
Inspect for damages, wear, valve adjustment, leaks. Ensure safety labels are legible.
Jack not lifting: check oil. Motor slow/stops: check air filter.
Load dropping: change valve cores. Cylinder leaks: change seals. Check for handling errors.
Replace worn/broken parts with genuine manufacturer parts only.
Oil must be drained off and legally disposed of.
Diagram illustrating the hydraulic system of the jack.
Details and part numbers for optional saddles and extensions for the jack.
Special extension may not be used with other extensions.
Statement of conformity with EC Machinery Directive 2006/42/EC and related regulations.
To Next Page
General