How to fix an ACCO Brands Chain Hoist that does not work?
If your ACCO Brands Chain Hoist isn't working, first ensure the emergency stop button is deactivated. Next, check that the main switch is turned on. If the issue persists, the push button contactor may be faulty and require replacement.
What to do if my ACCO Brands Chain Hoists makes abnormal noises while moving load?
If you notice abnormal noises while moving a load with your ACCO Brands Chain Hoists, several factors could be at play. Start by lubricating the chain components. If the noise persists, inspect the chain, load sheave, chain guide, and idler sheave for wear; replace worn parts as needed. Also, check the connection of the phases, because a supply phase might be missing.
Why ACCO Brands ACCOLIFT CLH motor malfunction?
If your ACCO Brands Chain Hoists motor is malfunctioning, begin by inspecting the power cable, terminal, and push button switch contact, repairing or replacing any faulty components. Also, if there is noise and over current flow, the hoist might be overloaded; ensure you operate it within its rated capacity. Finally, if there is noise and overheating, check the fuse, voltage, and connection of the 3-phase power.
What to do if ACCO Brands ACCOLIFT CLH Chain Hoists has electric leakage?
If you experience electric leakage in your ACCO Brands Chain Hoists, where there is electric flow on the hoist body and chain, check the connection to an earth ground. Also, check the insulation resistance. Finally, check for moisture on the push button and dry it.
Why travel direction of ACCO Brands Chain Hoists does not correspond to that indicated on the push button?
If the travel direction of your ACCO Brands Chain Hoists does not correspond to that indicated on the push button, the power supply is likely incorrectly connected. To resolve this, change two phases of the power supply.
Explains DANGER, WARNING, and CAUTION symbols for hazard identification.
Covers warnings, cautions, and identification labels for safe operation.
Details key installation procedures including electrical setup and component fitting.
Details trolley mounting on I-beam and electric power source connection.
Lists essential precautions for operating the hoist safely.
Recommends periodic maintenance checks, lubrication, and technical support.
Provides solutions for common hoist problems like motor malfunction or electrical leakage.
Wiring schematics for various 3-phase hoist models.
General| Brand | ACCO Brands |
|---|---|
| Model | ACCOLIFT CLH |
| Category | Chain Hoists |
| Language | English |
To Next Page