Accord XPC - Group 4 & 5 System Options: User and Power Settings; Easy Set and Power Fail Prevention; Group 5: System Options Overview

23
IE1-1230-B February 2001
3. Alarm
This sets the output to 12 V switching to 0 V when any of the following occur:
 Alarm Condition.
 Panic Alarm.
 Fire Alarm.
This output may be used to trip a transistorized relay for control of auxiliary equipment.
The alarm trigger can also be inverted so that it is normally 0 V switching to 12 V, see
Programming Group 5 Option 7 Trigger Output.
This option defaults to (3) Alarm.
Table 3.10 Group 5 System Options
SNOITPOMETSYS
PUORGNOITPOTLUAFED
5.)seY=1,oN=0(ssoLCAfogninraWelbiduA=1)0(
5.)seY=1,oN=0(yrtnEyratnemelppuS=2)0(
5
.smralArofteseRreenignE=3
.)erotsinhceTroreenignE=3,erotsinhceT=2,reenignE=1,remotsuC=0(
)0(
5.)seY=1,oN=0(elbanEyektoH=4)0(
5.)seY=1,oN=0(dapyeKtimOotuA=5)0(
5.)devomeR.geN=1,deilppA.geN=0(tuptuOlleB=6)0(
5.)devomeR.geN=1,deilppA.geN=0(tuptuOreggirT=7)0(
5
.srepmaTyaDrofteseRreenignE=8
.)erotsinhceTroreenignE=3,erotsinhceT=2,reenignE=1,remotsuC=0(
)0(
5.).L.O.E=2,decnalaBelbuoD=1,pooLC/N=0(noitarugifnoCenoZ=9)0(
System Programming  Group 5 System Options
Group five programming is as follows:
1. The first digit entered is 5 for System Options.
2. The second digit is the required system option 1  9.
3. The third digit is the option value.
Group 4  Option 9 Prevent Setting for Power Fails
This option determines which power fail conditions prevent setting of the system:
0. Mains fail.
1. Low battery.
2. Mains fail and low battery.
This option defaults to 0 (mains fail).
Group 4  Option 8 Easy Set
When enabled (1) this option allows users to (Full, Part or Night) set the system without
entering a user code.
When enabled users set the system by pressing the # key and : 1 (to Full Set), 2 (to Part
Set), or 3 (to Night Set). The same exit times as apply as with Full, Part and Night Set. A
valid user code is still required to unset the system.
This option defaults to 0 (disabled).