TO USE THE WEATHER FORECAST
There are five types of weather display in your weather station: Fig 4 > Sunny > Partly cloudy > Cloudy > Rainy > Freezing or Snow
Note: For better use of your weather station, place it at a location with open air circulation e.g. close by an open window. Placing it in an air-conditioned
environment will affect its accuracy. After your weather station is powered up, it will take around 24 hours to get stable. The weather icons on the display give
a reference to the next 6-12 hours weather conditions. It may not match with the current weather condition outside.
The Freezing or Snow icon will show if the weather forecast is Rainy and outdoor temperature is under 0 °C.
The Frost Alert “ ” icon will show if the outdoor temperature is between -2 0°C ~ +3 0°C.
BAROMETRIC TREND INDICATOR
The trend indicator on the display indicates the trend of the barometric pressure.
Barometric pressure trend rising
Barometric pressure trend falling
Barometric pressure trend steady
TO SELECT TEMPERATURE IN DEGREE °C OR °F
In normal time mode, press the °C/°F button once to select °C or °F.
Indoor measurable range -10~50°C.
Outdoor measurable range -20~50°C.
Note: If the temperature is out of the measurable range, LL.L (beyond minimum temp) or HH.H (beyond maximum temp) will show on the display.
TO VIEW MAXIMUM-MINIMUM TEMPERATURES/AIR HUMIDITY
In normal time mode, press the MIN/MAX button once, the maximum temperature/air humidity reading with ‘MAX’ icon will appear on the display. Press
MIN/MAX button once again, the minimum temperature/air humidity reading with ‘MIN’ icon will appear on the display.
Note: Humidity measurable range is 20% ~ 99%. If the current humidity measurement is lower than 20%, the LCD will display . If the current humidity
measurement it higher than 99%, the LCD will display 99%.
OUTDOOR TEMPERATURE ALERT FUNCTION
To set: Press and hold the ALERT button for 3 seconds, the “ ” (upper) icon flashes on the display next to outdoor temperature. Press or button to adjust the
setting value. Press ALERT button again, the “ ” (lower) icon lashes on the display next to outdoor temperature. Press or button to adjust the setting value.
Press ALERT button to confirm the setting.
To turn ON/OFF: Press ALERT button to turn on upper temperature alert, the “ ” icon will display. Press ALERT button again to turn on both upper/lower
temperature alert, “ ” and “ ” icon will display. Press “ALERT” button again to turn off upper temperature alert, “ ” icon will display. Press ALERT button
again to turn off lower temperature alert.
MOON PHASE
The Moon phase will automatically change according to the current date displayed on the clock.
PROJECTION
Press the projection ON/OFF button to turn on or off the projection. When the projection is on, press and hold the ON/OFF button for 3 seconds to reverse the
projection 180°. Turn the projection wheel to adjust the focus. Press SNOOZE/LIGHT button 1,2,3 or 4 times to select between the following viewing options -
Weather forecast and time, Weather forecast and indoor temp, Weather forecast and outdoor temp or display alternating all options, the “ ” icon will
display.
BACKLIGHT DIMMER FUNCTION
When clock is powered by USB, press the DIMMER button 1,2 or 3 times to adjust brightness of the backlight. Note: When clock is powered by battery only the
dimmer function will not work. Press SNOOZE/LIGHT to activate backlight for a few seconds.
LOW BATTERY INDICATOR
The low battery icon “ ” will show next to outdoor temperature when the batteries in the outdoor sensor need to be replaced.
RESET BUTTON
Press the reset button if the clock is not working properly.
IMPORTANT NOTE: Avoid placing the clock near interference sources/metal frames such as computer or TV sets. Do not expose it to direct sunlight, heavy heat,
cold, high humidity or wet areas. The outdoor sensor must not be set up and installed under water, set it up away from direct sunlight and rain. Never clean the
device using abrasive or corrosive materials or products.
CHANGING THE BATTERIES
It is recommended that you replace the batteries annually even if the product is still running. Only use 2 X AA (1.5V) Alkaline batteries in this clock. Do not mix
old and new batteries, different types or brands. Remove the batteries if the clock is stored or not in use. Remove exhausted batteries from the product.
Warning: Do not recharge non-rechargeable batteries. Please dispose of used battery in a responsible manner. For more information please contact your local
authority.
SAFETY
This electric clock may represent a hazard for young children. Keep this clock out of reach of small children to avoid risk of shock or possible choking hazard
from small parts.
YOUR GUARANTEE
Your clock is guaranteed for 2 years from the date of purchase against any faults arising from defective materials or manufacture. Damage caused through
careless handling, misuse or in transit is expressly excluded. Should this clock fail within 2 years please return it to your retailer.
Environmental Protection
Disposal of electrical & electronic equipment
Do not dispose of this product with household waste. For the proper treatment, recovery and recycling please take this product to the appropriate
collection point. If you are unsure of where this is contact your local authority. Improper disposal may be harmful to the environment.
To download your instructions, scan the QR code and enter 16183
Para descargar sus instrucciones, escanee el código QR e ingrese 16183
Pour télécharger vos instructions, scannez le code QR et entrez 16183
Per scaricare le istruzioni, scansiona il codice QR e inserisci 16183
Um Ihre Anweisungen herunterzuladen, scannen Sie den QR-Code und geben Sie ein 16183
AL508_V.1
For more innovative Acctim products please visit: www.acctim.com
EN
ES
FR
DE
IT
%
To Previous Page
Loading...