214
Series
Note: If you select the “AUTO” mode, please go to step 10 directly and reset
module. Wait until the reset is finished and find the new IP address in the
following step.
Fig 5-70
d). Set IP Address in the second setting page, such as 192.168.1.100 as shown
below. Press the "V/A" key to go to the IP setting page. Users may set the
parameters in the area pointed out in Fig 5-78. The cursor starts at the rst digit.
After setting the IP address press the "V/A" key to accept. Press the "P" key again
to go to the third setting page for Subnet Mask.
To Next Page
Loading...
