1313
8) 8) TTo connect the load with the UPS, please turn ofo connect the load with the UPS, please turn off all the loadsf all the loads
first, then perform the connection and finally turn on the loadsfirst, then perform the connection and finally turn on the loads
one by one.one by one.
9) 9) No matter the No matter the UPS is connected UPS is connected to the utility power to the utility power or not, theor not, the
output of the UPS may have electricity. The parts inside the unitoutput of the UPS may have electricity. The parts inside the unit
may still have hazardous voltage after turning off the UPS. Tomay still have hazardous voltage after turning off the UPS. To
make the UPS have no output, power off the UPS, and thenmake the UPS have no output, power off the UPS, and then
disconnect the utility power supply.disconnect the utility power supply.
10) 10) Suggest Suggest charging charging the batterithe batteries es for for 8 8 hours before hours before use. Afteruse. After
connection, turn the input breaker in the “ON” position, the UPSconnection, turn the input breaker in the “ON” position, the UPS
will cwill charge the batteries automatiharge the batteries automaticallycally. Y. You can also ou can also use the UPSuse the UPS
immediately without charging the batteries first, but the backupimmediately without charging the batteries first, but the backup
time may be less than the standard value.time may be less than the standard value.
111) 1) If iIf it is t is necessary to necessary to connect the connect the inductance linductance load such oad such as aas a
monitor or a laser printer to the UPS, the start-up power shouldmonitor or a laser printer to the UPS, the start-up power should
be used for calculating the capacity of the UPS, as its start-upbe used for calculating the capacity of the UPS, as its start-up
power consumption is too big when it is started.power consumption is too big when it is started.
Important notes: If the UPS is used in single mode, JPI and JP2 mustImportant notes: If the UPS is used in single mode, JPI and JP2 must
be connected by be connected by 10A10AWG(6mmWG(6mm
22
). If the UPS is used in parallel mode,). If the UPS is used in parallel mode,
JP1 and JP2 must be disconnected.JP1 and JP2 must be disconnected.
Input and output Input and output TTerminal Block erminal Block wiring diagram wiring diagram of TN26000(S)/TN2-10000(S)of TN26000(S)/TN2-10000(S)
To Next Page
Loading...