1919
6. Operation6. Operation
6.1 Operation Mode6.1 Operation Mode
1. Turn on the UPS with utility power supplied (in Line mode)1. Turn on the UPS with utility power supplied (in Line mode)
1) 1) After you After you make sure that make sure that the power the power supply connection issupply connection is
correct, and then set the breaker of the battery pack in the “ON”correct, and then set the breaker of the battery pack in the “ON”
position (this step only for UPS with external battery), after thatposition (this step only for UPS with external battery), after that
set set the the input breaker input breaker in thin the e “ON” “ON” position. position. At this At this time the time the fanfan
rotates and the UPS supplies power to the load via the bypass.rotates and the UPS supplies power to the load via the bypass.
The UPS operates in Bypass mode, the mode code is “01”.The UPS operates in Bypass mode, the mode code is “01”.
2) To power on the UPS by simply pressing the ON button2) To power on the UPS by simply pressing the ON button
continuously for more than 1 second, the buzzer will beep once.continuously for more than 1 second, the buzzer will beep once.
3) 3) A A few seconds laterfew seconds later, the U, the UPS turn into LPS turn into Line mode, and ine mode, and the modethe mode
code is “02”. If the utility power is abnormal, the UPS willcode is “02”. If the utility power is abnormal, the UPS will
operate in Battery mode without output interruption of the UPS.operate in Battery mode without output interruption of the UPS.
2. Turn on the UPS with no utility power supplied (in Battery2. Turn on the UPS with no utility power supplied (in Battery
mode)mode)
1) 1) After you make After you make sure that the sure that the breaker of the breaker of the battery pack is battery pack is in thein the
“ON” position (this step only for UPS with external battery).“ON” position (this step only for UPS with external battery).
2) 2) Press the ON buttoPress the ON button continuously for n continuously for more than 1 more than 1 second tosecond to
power on the UPS, and the buzzer will beep once, UPSpower on the UPS, and the buzzer will beep once, UPS
operates in No Output mode, the mode code is “00”.operates in No Output mode, the mode code is “00”.
3) 3) A A few seconds laterfew seconds later, the UPS turn , the UPS turn into Battery mode, and theinto Battery mode, and the
mode code is “03”.mode code is “03”.
3. Turn off the UPS with utility power supplied (in Line mode)3. Turn off the UPS with utility power supplied (in Line mode)
1) 1) TTo turn off the o turn off the inverter of the UPS by pressing the inverter of the UPS by pressing the OFF buttonOFF button
continuously for more than 1 second, and the buzzer will beepcontinuously for more than 1 second, and the buzzer will beep
once. The UPS will turn into Bypass mode.once. The UPS will turn into Bypass mode.
2) 2) Upon completion of the abovUpon completion of the above to turn e to turn it off, output of electricit off, output of electric
current of the UPS is still present. In order to cut off the outputcurrent of the UPS is still present. In order to cut off the output
To Next Page
Loading...