INSTRUCTION SHEET
WARNING!
Do not exceed Charging Guidelines that are listed on the chart.
Prolonged charging or use of a constant current charger could shorten
battery life.
4. Removal/Installation
a. Remove old battery. Mark which cable is connected to the Positive
(+) and Negative (-) posts. Clean cable terminals with wire brush or
sandpaper to remove oxidation. Position new fully charged battery
on tray, connect clear vent tube to battery, ensuring there are no
crimps, folds or blockages. Replace hold down.
b. Connect terminals:
i. Positive (+) red cable from ignition to Positive Post.
ii. Negative (-) black cable from engine or chassis to Negative
Post.
Charging Guidelines:
Using a charger with an output of 1.0amps the initial charge time of the
battery will be approximately 1/2 to 1x the amp hour rating for that
battery. Full charge voltage for a flooded battery is approximately 12.7V
to 12.8V.
See Chart Below
To Next Page
Loading...