89 Altos R520 Installation Configuration Guide
driver from the EasyBUILD to HDD first.
# mount /dev/dvd /mnt
# cp –R /mnt/Disk/R520/NIC/Intel/pro1000.lx/. /tmp
2. Remove the OS built-in NIC driver
# rmmod e1000.ko
3. Change the directory to the driver source and install the driver
# cd /tmp/src/
# make install
# insmod e1000.ko
4. Run the kudzu utility, it will auto detect the Gigabit Ethernet controller
and help you to configure it.
# kudzu
5. Restart the network service to bring up both of the network interfaces.
# service network restart
IOAT driver installation
1. Please remove the old version of IOAT driver from the system manually.
# cd /lib/modules/$(uname -r)/kernel/drivers/dma
# mv ioatdma.ko ioatdma.ko.bak
2. You can find the IOAT driver in EasyBUILD. Please copy the driver from the
EasyBUILD to HDD first.
Copy the IOAT driver to /tmp
# cd /tmp
# tar zxf ioatdma-<ioat version>.tar.gz
3. Install the IOAT driver
# cd ioatdma-<ioat version>
# make install
4. Load the IOAT driver
# modprobe dca
# cd ioatdma
# insmod ioatdma.ko
# modprobe ioatdma
# ll /sys/class/dma/
To Next Page
Loading...
