Altos R520 Installation Configuration Guide 74
5.0 EM64T on Altos R520 with integrated SAS hardware RAID.
Drivers Required
For Red Hat Enterprise Linux 5.0 EM64T Installation, the following device
drivers are required.
Device Version EasyBUILD Version
Integrated SAS
hardware RAID
00.00.03.09 EasyBUILD 8.0 build 100 (or later)
Onboard Chipset N/A OS built-in
Onboard Gigabit
Ethernet
7.6.5 EasyBUILD 8.0 build 100 (or later)
Onboard VGA N/A OS built-in
Onboard USB 2.0 N/A OS built-in
IOAT 2.15 EasyBUILD 8.0 build 200 (or later)
Software Required
The management utility of integrated SAS hardware RAID can be found in the
EasyBUILD.
Software Version EasyBUILD Version
RAID Web Console
2
2.19-01 EasyBUILD 8.0 build 100 (or later)
Configuring integrated SAS hardware RAID
Please refer to the Appendix A. for the integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. There is no built-in driver for Integrated SAS hardware RAID in the Red
Hat Enterprise Linux 5.0 EM64T. You need an external USB floppy drive for
applying driver during the OS installation.
4. Since Red Hat Enterprise Linux 5.0 EM64T cannot recognize the
integrated SAS hardware RAID, you need to make a driver diskette from
the EasyBUILD first before the installation.
5. Type linux dd when the prompt boot: appears at the start.
6. Please select the sda as the Driver Disk Source.
7. Follow the instruction to load the integrated SAS hardware RAID driver
from the driver diskette.
8. At the package selection step, select Software Development for the
installation package.
9. Please follow the normal procedure to finish the installation.
To Next Page
Loading...
