1 System tour
12
Mainboard jumper settings
No. Code Function Setting
1 JPL1 Enable Gigabit
LAN ports
1-2 Close: Enabled (default setting)
2-3 Close: Disabled
2 JWD1 Enable watchdog 1-2 Close: Reset (default setting)
2-3 Close: NMI
Open: Disabled
3 JPG1 Enable VGA port 1-2 Close: Enabled (default setting)
2-3 Close: Disabled
4 JPB1 Enable BMC 1-2 Close: Enabled
2-3 Close: Normal (default setting)
5 JBT1 Clear CMOS To clear CMOS, use a metal object
such as a small screwdriver to touch
both pads at the same time to
short the connection.
To Next Page
Loading...
