33
Power
supply
installation
/
Removal
The AT310 F2 supports 450 watts power supply modules. With different SKU, it has fix power supply module
and hot-swap power supply module. The system ships out with only one power supply module installed.
Install a fix power supply module
1. Remove the four securing screws.
2. Slide toward and lift to remove the power supply module from the system.
3. To install a new power supply module, please reverse the installation step 1and 2.
4. After replacing a power supply module, connect the necessary cables.
Install a hot-swap power supply module
1. Press the retaining clip on the right side of the power supply along the direction of the arrow.
2. At the same time, pull out the power supply by using its handle.
3. To install a new power supply module, please reverse the installation step 1and 2.
4. After replacing a power supply module, connect the necessary cables.
To Next Page
Loading...
