Acer ED323QU - System Settings Configuration

15
English
Adjusting the System settings
The setting options include:
• Input: Selects the input source (HDMI1 / HDMI2 / DP1 / DP2).
• Auto Source: Enables/Disables the monitor to automatically search for
available input sources (Off / On).
• Wide Mode: Adjusts the aspect ratio of the monitor (Full / Aspect / 1:1)
• Hot Key Assignment: Assigns the function that the hot keys on the OSD portal
will access.
• Hot Key 1 (Modes / Brightness / Volume / Gamma / Contrast / Blue Light /
Over Drive / VRB)
• Hot Key 2 (Modes / Brightness / Volume / Gamma / Contrast / Blue Light /
Over Drive / VRB)
• DDC/CI: Enables/Disables you to configure the monitor using software
installed on your computer (Off / On).
Note: DDC/CI stands for Display Data Channel/Command Interface. It
enables users to send commands to adjust the monitor’s configurations.
• HDMI Black Level: Adjusts the black level range of an HDMI input source
(Normal / Low).
• Quick Start Mode: Speeds up the monitor’s boot-up process (Off / On).
15
English
• Auto Source: Enables/Disables the monitor to automacally search for
available input sources ( / On).
• Wide Mode: Adjusts the aspect rator (Full / Aspect / 1:1)
• Hot Key Assignmentat the hot keys on the OSD portal
will access.
• Hot Key 1 (Modes / Brightness / Volume / Gamma / Contrast / Blue Light /
Over Drive / VRB)
• Hot Key 2 (Modes / Brightness / Volume / Gamma / Contrast / Blue Light /
Over Drive / VRB)
Note: 

Informa
The sep
• Reset All Se: Resets the OSD menu to its default se
• Exit: Exits the OSD menu.