Acer Nitro 5 - Page 27

Disassembly Procedures 1-25
Mainboard Removal
Prerequisite:
DIMM Modules Removal on page 1-10
WLAN Module Removal on page 1-13
SSD 1 Module Removal on page 1-15
SSD 2 Module Removal on page 1-17
Thermal and Fan Modules Removal
NOTE:
Please note that the eDP cable includes the LCD panel cable and the camera cable.
1. Release the WLAN antenna cables from the clips. Then put the cables away from the
mainboard.
2. Release the latch (if necessary) and disconnect the following cables from the mainboard
connectors:
• Right speaker (A)
• HDD FFC (B)
• RTC battery cable (C)
• Keyboard backlight FPC (D)
• Touchpad FFC (E)
• Keyboard FPC (F)
• USB board FFC (G)
• USB board cable (H)
• eDP cable (I)
Figure 1-31. Disconnecting the Cables (GN20-P0/GN20-P1 model)
A
D
B
F
C
E
H
G
I