Acer Predator CG437K

CG437K User Guide English 25
Mode - Standard
Picture
Color
Audio
OSD
Enter
Move
System
Gaming
Off
Quick start mode
Off
4K-144Hz Mode
Off
Power Sensor
Off
USB 3.0
Off
Power-off
USB Charge
HDMI Black Level
Normal
X
18. Power Sensor: The power sensor is set to (level 1 to level 4), tolerance is (+/-) 10
cm and ACM is off and grayed out.
------------------------------------------------------------------------------------------------------
Note:
• The power sensor is turned on and ACM is automatically set to off.
• Three status (No signal, no cable connection and out of range) does not support
power sensor.
• Power The detection range of the Sensor is in the middle, and the left and right
sides are Less than 30 degrees. The upper and lower are ignored.
• A failure occurs temporarily when operating the OSD. The power sensor will be
recovered after the OSD disappears.
19. USB 3.0
：
The default is "Off", can to controls determine the USB bandwidth.
------------------------------------------------------------------------------------------------------
Note:
• Only support the DP ALT can control USB3.0, other Input will be gray out and
unavailable.
• USB3.0 is set on, the DP ALT can support max resolution is 3840x2160-30Hz.
• USB3.0 is set off, the DP ALT can support max resolution is 3840x2160-60Hz.
20. Power-off USB charge: Turn On or Off. On: DC off/Saving mode can to electrify for
USB port. Off: DC off/Saving mode can't to electrify for USB port.
------------------------------------------------------------------------------------------------------
Note:
Power-off USB charge is set to off by default. Therefore, the sleep mode cannot
be resumed under the USB Type-C input. The user needs to change the Power-off USB to
on.