33
ACER S230HL
Go to contents page
4. Assembly and Disassembly Procedures
S8
Assembling Rear Cover with the assembled unit .Pressing the Rear Cover to make the hook structure
assembled well.
S9
Using the Phillips-head screwdriver to tighten bracket of D-sub for fixing on the
Rear Cover with two M3 screws.
(Screw size = MAC. SCREW-MB M3.0*5.0L,BLK-Ni ,Torque=4±1kgf.cm)
S10
1: Putting the Neck into the holes of Rear Cover’s bottom area as red square of area shown.
2: Pushing the neck as red arrow shown.
To Next Page
Loading...
