2
Attaching/removing the base
STEP 1
STEP 2
Installation: Align the base with the stand and push the base towards the top of the monitor,
and then rotate the base clockwise. Tighten the screw clockwise.
Remove:
1. Reverse the steps to remove the base.
2. Use a screwdriver to press the shrapnel of back cover to remove the stand at the
same time.
Note: Take care when performing the installation to avoid injuring yourself.
If installing with a wall mounting kit, install 2 extension columns into the copper stud in the
back cover (as below picture), it is recommended to use VESA mounting kit (100 x 100) with
M4 x 10(L) mm screws to x your monitor on the wall.
To Next Page
Loading...
