EN-21
9. PIP/PBP: The options for PIP/PBP Mode are Off, PIP Large, PIP Small, and
PBP. You can also adjust the PIP Position, PBP Size, Sub Source, Source
Swap, and Audio Source.
10. DDC/CI: Allows the monitor settings to be set through the software on
the PC.
11. HDMI Black Level: You can select the level of blackness under HDMI
source. The options are Normal and Low.
12. Quick Start Mode: Enable monitor rapidly.
13. Over Clock: Turn this function On to support refresh rate at 270 Hz. The
default is Off.
14. Power-off USB charge (Optional): Turn On or Off.
Product information
1. From any function page, press the key to open the OSD.
2. Reset All Settings: Reset all settings to the factory defaults.
Note: DDC/CI, short for Display Data Channel/Command Interface,
which allows monitor controls to be sent via software.
Note: When Over Clock is On, Adaptive-Sync is automatically turned
off.
To Next Page
Loading...
