ENGLISH
- 10 -
STORAGE OF TRANSMITTERS
The storage of transmitters can be performed for 1-key or 3-key
operation (see OPERATION paragraph).
NOTE: a transmitter that is stored for 1-key operation
cannot be stored also for 3-key operation and vice versa.
1. Press the PROG button until the buzzer activates
2. Release the button: the LED lights up and stays on for 4
seconds to indicate that the control unit is ready to store the
transmitters
3. - 1-key operation:
press the transmitter button: the LED flashes and the
buzzer is activated to indicate the storage of the codes
- 3-key operation:
press keys 1 and 3 simultaneously: the LED flashes and the
buzzer is activated to indicate the storage of codes. Keys
will be stored with the following functions
4. Store all desired transmitters
5. After 2 seconds without receiving any code, the control unit
automatically exits the procedure: the LED turns off and the
buzzer emits two short acoustic signals
CANCELLATION OF ALL TRANSMITTERS
Press the PROG button for 6 seconds: the LED flashes and the
buzzer emits a short acoustic signal to indicate that the codes
have been cancelled.
OUT OF MEMORY INDICATION
When the control unit has stored the maximum number of
transmitters, by attempting to store a new code, the control unit
signals the anomaly by means of LED flashes and buzzer acoustic
signals for 10 seconds, then exits the program.
To Next Page
Loading...
