ACME MP-12FC - DMX Addressing and Channel Modes; Configuring Operating Modes

DMX 512 Address Setting
Press the MENU button up to when the is shown on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to change the DMX 512 address.
Once the address has been selected, press ENTER button to setup or automatically exit
menu mode without any change after 7seconds. Back to the previous functions without any
change press MENU button.
Channel Mode
Press the MENU button up to when the
is shown on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to select the
(4
channels mode) or
(5 channels mode) or (8 channels mode). Once the
mode has been selected, press the ENTER button to setup or automatically exit menu mode
without any change after 7seconds To go back to the functions without any change press
the MENU button.
Slave Mode
Press the MENU button up to when the
is showing on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to select the
(normal)
or
(slave 2) mode. Once the mode has been selected, press the ENTER button to
setup or automatically return to the main functions without any change after7seconds. To go
back to the functions without any change press the MENU button again.
Show Mode
Press the MENU button up to when the
is shown on the display. Pressing ENTER
button, Use DOWN and UP button to select the
(Random show) or (color)
or
(fade), if you select the color or fade mode, press ENTER button to confirm, and
use DOWN and UP button to select color 1-10 or fade speed (speed 1: slow, speed 2:
middle, speed 3: fast). Once select, press ENTER button to setup or automatically exit menu
mode without any change after 7seconds. To go back to the last function without any
7 A