Acom ACOM2100 - Page 10

10
Fig.3-2 Information Screens and Control Functions Structure
The OPER button changes operate and standby modes alternatively (S.4-2) while ON LINE. Please
note that Auto-Operate might be enabled (S.5-2). The same button activates signature list while OFF
LINE (S.5-3).
The PREV and NEXT buttons change information screens or select control functions (S. 4-6) for both
OFF LINE and ON LINE modes.
The ON/OFF button switches OFF LINE and ON LINE (OPERATION) states of the amplier alternatively.
You can proceed in one of two ways:
a) You may use the OFF LINE information screens and control functions. They refer to the auto-protection
signatures list, as well as the Auto-Operate feature and Antenna assignment. This is described in S5.
b) You may turn on the amplier and start the warm-up sequence. After 3 minutes you may tune and
begin operating the amplier and you can use the ON LINE (OPERATION) information screens or control
functions (see below).