Now you can slowly attend the M4
Allen setscrew at the rear top end of the
arché’s head.
By doing so the rear end of the mount-
ing plate will go down and the angle of
the cartridgewill change.
When you have reach the desired posi-
tion, make sure to fasten the M2 Allen
front screw again. The small silver plate
you found among the arché accessories
may help you in returning to a prior set
angle after trying a different position.
You can use the Allen wrench as an
“indicator” - as pictured.
Please note: this is just a “helping” -
it is neither a precise indication nor
an absolute value given here.
To Next Page
Loading...