Acromag BusWorks 900EN Series User Manual (English)

Questions and Answers:

D
Daniel ChungAug 11, 2025
What to do if I cannot communicate with Acromag I/O Systems?
- K
  Keith WilliamsAug 11, 2025
  If you cannot establish communication with your Acromag I/O Systems module, consider these potential causes: * **Power:** Verify that the module is powered ON and that the green RUN LED is illuminated. * **Cable Type:** Ensure you are using the correct type of Ethernet cable. A crossover cable is needed when connecting directly to a PC or another MDI device. A direct cable should be used when connecting to an Ethernet switch or hub. Note that even with the Link LED ON, the cable could still be defective. * **IP Address:** Confirm that the IP address of both the module and your PC are compatible and on the same network. Try the default module address of 128.1.1.100, and use a different address for your PC's NIC.
H
Herbert MyersAug 17, 2025
Why am I getting many communication errors with my Acromag I/O Systems?
- T
  Theresa ShieldsAug 17, 2025
  Frequent communication errors with your Acromag I/O Systems could stem from several factors: * **Cable Length:** Ensure that the cable segment does not exceed 100 meters when connecting two nodes. * **Cable Type:** It is recommended to use shielded CAT-5/5E cable or equivalent. * **Grounding:** Verify that the earth ground is properly connected to the TB3-33 GND terminal located next to the power terminal.
V
vfosterAug 22, 2025
How to fix 'Cannot Browse Module' error on Acromag BusWorks 900EN?
- P
  priscilla60Aug 22, 2025
  If you are unable to browse the module, it is possible that your browser is configured to utilize a proxy server for LAN communications. Temporarily disable the proxy server settings in your browser to resolve this issue.
N
nthompsonAug 28, 2025
What does a continuous flashing green RUN LED mean on Acromag I/O Systems?
- A
  Alyssa CunninghamAug 28, 2025
  A continuous flashing green RUN LED indicates that the Acromag I/O Systems module is in “wink” mode. To verify this, read the Module Status register. To toggle wink mode off or on, write 5555H to the Wink Mode Toggle Register.
H
Hannah PorterSep 3, 2025
What to do if the green RUN LED does not light on Acromag BusWorks 900EN I/O Systems?
- S
  Sheila JohnsonSep 3, 2025
  If the green RUN LED on your Acromag I/O Systems module does not light up, it suggests that the internal +3.3V power has failed. In this case, return the module for repair.

Acromag BusWorks 900EN Series Specifications

General

Brand	Acromag
Model	BusWorks 900EN Series
Category	I/O Systems
Language	English

Related product manuals

Acromag AcroPack Series

78 pages

Acromag BusWorks 900EN Series User Manual

Table of Contents

Questions and Answers:

Acromag BusWorks 900EN Series Specifications

Related product manuals