EasyManua.ls Logo

ACT 4-LINE - NETWORK WIRING User Manual

ACT 4-LINE - NETWORK WIRING
1 page
Page #1 background imageLoading...
Page #1 background image
To PC
To Mains Supply
ACT 4-Line Nework Interface Card
All lines are equivalent and operate in parallel
Any controller may be connected to any line.
Network cable use either:
(1)Single shielded twisted pair: Belden 9501 or similar.
(2)CAT5 Cable: A/B must share the same twisted pair.
ACTpro 3000 ACTpro 1000 ACTpro 1000
Line 1
Line 2
Line 3
Line 4
SCN C DI DO
+BAT-
NETWORK PRINTER
Timekeeper
Lithium Battery
A
B
0V
TX
RX
Timekeeper
Lithium Battery
A
B
0V
TX
RX
Each line may be up to 1.4km in length
and connect up to 32 controllers
ACTpro 3000
ACTpro 1000
ACTpro 2000
Shield
Network printer
Timekeeper
Lithium Battery
C 1 2
C 1 2
C 1 2
C 1 2
~AC~
RS485
RS485 232 Interface
Converter
LED2
LED3
To next door
A
NETWORK 1
B
A
B
A
B
DTR
RX
TX
0V
A
B
0V
A
B
0V
TX
RX
A
B
0V
DOORS
SERIAL/PRINTER
DTR
RX
TX
0V
A
B
0V
Shield
120R Resistor
on last node.
C = SHIELD
1 = B
2 = A
RS232
PORT
SCN = Pin 5
C = Pin 7
DI = Pin 3
D0 = Pin 2
Connections for 9 Way
Connector of PC
L E N
A B OV
NETWORK PRINTER
A B OV
NETWORK 1
NETWORK 1
A B OV
ACT 4-Line Network Wiring
LED 2 (DIRECTION) Normally Flickering
LED 3 (FLT) Normally On
SERIAL/PRINTER
DOORS
DOORS
CTS
A B OV
NETWORK 2
18 - 00047
Unit C1, South City Business Centre,Tallaght, Dublin 24, Ireland.
Phone: +353 1 466 2570. Fax: +353 1 452 0427. UK LoCall 0845 300 5204 E-mail: sales@accesscontrol.ie Web: www.accesscontrol.ie
Question and Answer IconNeed help?

Do you have a question about the ACT 4-LINE - NETWORK WIRING and is the answer not in the manual?

ACT 4-LINE - NETWORK WIRING Specifications

General IconGeneral
BrandACT
Model4-LINE - NETWORK WIRING
CategoryRecording Equipment
LanguageEnglish

Summary

ACT 4-Line Network Wiring Overview

ACT Interface Card and PC Connectivity

Details the RS485 converter, LED indicators, and PC connection specifications for the interface card.

Network Cable and Line Specifications

Explains network cable choices, line length limits, and controller capacity per line.

ACTpro Controller Wiring Details

Illustrates network, doors, and serial/printer connections for ACTpro 3000, 1000, and 2000 models.

Network Termination Requirement

Specifies the need for a 120 Ohm termination resistor on the final node in the network.