8-16
USER MANUAL 750000992/16
File management MTS
e
Cable Id. Choose an identification name for the cable. The first three
characters of this name are used for the file name when
automatic file naming
*
is selected.
Fiber Number Select the identification number of the fiber from 0 to 999.
This number is used in the file name when automatic file
naming is selected.
Auto increment Selection of auto-increment file name function. The fiber
number automatically is incremented at each save
operation. This number is also incremented in the file name
(auto mode).
Origin Location Allows a name to be entered for the origin of the fiber.
End Location Allows a name to be entered for the end of the fiber.
Direction Selection of the measurement direction: O → E (origin to
extremity) or E → O.
Comments
The Comments zone allows the operator to enter with the Edit menu, comments
about the file for future reference when the file is reloaded.
This zone contains 3 independent lines of 31 characters.
Manipulating stored data
You can carry out any of the following operations on the data files stored on
floppy or internal storage medium: <Load>, <Overlay>, <Copy>, <Delete> or
<Rename>.
Note Only files compatible with the selected module can be loaded : for
example, you cannot load an OTS file if an OTDR module is selected.
Explore function
When the media is selected, press the <Explore> key. The display (see page 8-19)
presents three windows:
*. See "Filename" on page 8-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
