9-4
USER MANUAL 750000992/16
Remote control MTS
e
Command Syntax
• Commands include upper and lowercase characters
- only uppercase characters are required,
- lower case characters can be removed to abbreviate the commands.
• Successive nodes should be separated by a colon (:)
• A space should separate the last level node from any possible associated
parameter. If there are several parameters, a comma should separate them.
• Examples of command:
- complete: ACQUISITION:LASER L850
- abbreviated: ACQ:LAS L850
Abbreviation of command header
Generally, when the header has more than four characters, the following rules
are adopted:
• The first four characters of the header are used, except if the fourth is a vowel.
In the latter case the vowel is dropped and only the first three characters are
necessary.
Example: ACQ for ACQUISITION
MEAS for MEASUREMENT
• If the command is made from several words, the first letter of each word is
used, except for the last one (three or four first characters).
Example: MSL for Measurement Slope
DSPL for Display Splice
Linking commands
Successive commands should be separated by a semicolon(;).
Parameters
There are several parameter types:
• Numerical: decimal, signed and scientific numbers
Examples: 245, 687E2, -1.48E3, .426, 1.100E-4
• Key words. Examples: OFF, ON, YES, NO
• String of ASCII characters which should be enclosed within quotes
(") or (’)
Example: «TRACE TITLE»
Queries
The commands generally have an associated query.
• Most of the queries have no parameters. They are terminated by?
They are not specified in the following dictionary of the commands.
Examples:
SYST:PRIN? request the printer mode selected
IDEN:OPER? request the identification of the operator
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
