ActionTec GT724WGR Specifications

Creative Solutions for the Digital Life
™
Technical Specifications (cont’d)
IP
ARP
ICMP
UDP
TCP
IP Router
RIP
DHCP Server
DHCP Client
NAT, PAT
(IP Masquerading)
NAT ALGs
(Application
Level Gateway)
(NAT Pass Through)
RFC 791 “Internet Protocol”
RFC 950 “Internet Standard Subnetting Procedure”
RFC 1122 “Requirements for Internet Hosts –
Communication Layers”
RFC 1191 “Path MTU discovery”
RFC 1213“Management Information Base for Network
Management of TCP/IP-based Internet: MIB-II”
RFC 894 “Standard for the Transmission of IP
Datagrams Over Ethernet Networks”
RFC 826 “Ethernet Address Resolution Protocol: Or
Converting Network Protocol Addresses to 48-bit
Ethernet Address for Transmission on Ethernet
Hardware”
RFC 792 “Internet Control Message Protocol”
RFC 768 “User Datagram Protocol”
RFC 793 “Transmission Control Protocol”
Support Static Route
Support Unnumbered Mode
RFC 1058 “Routing Information Protocol”
RFC 1723 “RIP Version 2 - Carrying Additional
Information”
RFC 2453 “RIP Version 2”
RFC 1812 “Requirements for IP Version 4 Routers”
RFC 1191 “Path MTU Discovery”
RFC 2131 “Dynamic Host Configuration Protocol”
RFC 2132 “DHCP Options and BOOTP Vendor
Extensions”
RFC 2131 “Dynamic Host Configuration Protocol”
RFC 2132 “DHCP Options and BOOTP Vendor
Extensions”
The DHCP client supports the following minimal
subset of options described in RFC 2132:
• Requested IP Address (requested by default; is
mandatory)
• Parameter Request list (subnet-mask only)
• IP Address Lease time (dhcp-lease-time)
• Client-identifier (dhcp-client-identifier)
• Default route (routers)
• DNS proxy servers
RFC 2663 “IP Network Address Translator (NAT)
Terminology and Considerations”
RFC 3022 “Traditional IP Network Address
Translator (Traditional NAT)”
FTP (over NATP)
Netmeeting
IPSec
PPTP
NAT advanced
features
Firewall
Universal
Plug-N-Play
(UPnP)
PPPoA
PPPoE
RFC 1483/2684
TELNET
FTP
Server/Client
Web Server
and Web Based
Configuration
Operating Range
Environmental
Operating Range
Port Forwarding
DMZ
Service Blocking
Web site blocking
Web Activity Log
Stateful Firewall: multiple security levels
Basic IDS: Stateful Packet Inspection for prevention
of Denial of Service (DoS) attacks
Internet Gateway Device (IGD) Standardized Device
Control Protocol V 1.0
RFC 2364 “PPP Over AAL5”
RFC 2516 “Method for Transmitting PPP Over
Ethernet (PPPoE)”
Supports bridged 802.3 Ethernet frames over an
ATM network
• LLC encapsulation, in which an LLC/SNAP
header is prepended to the (Ethernet) frame
• VC multiplexing, in which a null two byte header
is prepended to the frame
Default is LLC encapsulation; VC multiplexing can be
configured using console command or WEB configuration
• RFC 1483 “Multiprotocol Encapsulation Over
ATM Adaptation Layer 5”
• RFC 1213 “Management Information Base for Network
Management of TCP/IP-based Internet: MIB-II”
• RFC 2684 “Multiprotocol Encapsulation Over
ATM Adaptation Layer 5”
RFC 854 “Telnet Protocol Specification”
RFC 855 “Telnet Option Specifications”
RFC 857 “Telnet Echo Option”
RFC 858 “Telnet Suppress Go Ahead Option”
RFC 1350 “The TFTP Protocol (Revision 2)”
FTP server is in boot loader only
RFC 1945 “Hypertext Transfer Protocol – HTTP/1.0”
RFC 2068 “Hypertext Transfer Protocol –
HTTP/1.1” (partial support)
RFC 2617 “HTTP Authentication: Basic and Digest
Access Authentication”
Indoors: Up to 13m (40 ft) @ 54 Mbps
Up to 17m (55 ft) @ 18 Mbps
Up to 37m (120 ft) @ 11 Mbps
Up to 91m (300 ft) @ 1 Mbps
Outdoors: Up to 55m (180 ft) @ 54 Mbps
Up to 122m (400 ft) @ 18 Mbps
Up to 171m (560 ft) @ 11 Mbps
Up to 533m (1,750 ft) @ 1 Mbps
Operating Temperature: 0-40 degrees Celsius
Humidity: 8-95% non-condensing
54 Mbps Wireless DSL Modem

ActionTec GT724WGR Specifications

General

Brand	ActionTec
Model	GT724WGR
Category	Modem
Language	English