4
3. Wind the knob at the back of the resistance roller until it gently touches the tyre (Fig.4).
It is important that you use a smooth treaded tyre and that it is inflated to the maximum
tyre pressure as stated on the sidewall of your tyre.
Fig.4
4. Attach the remove resistance lever to the handle bars of your bicycle,
ensuring that the cable is away from your pedals and rear wheels (Fig.5).
Fig.5
5. Place riser block under the front wheel of your bicycle to level up the bicycle and to
improve the comfort level (Fig.6).
Fig.6
To Next Page
Loading...