If necessary, fill the reserve tank
to the MAX mark. Install the
reserve tank cap.
Install the radiator cap, and
tighten it fully.
Start the engine and hold it at
1,500 rpm until the cooling fan
comes on. Turn off the engine.
Check the coolant level in the
radiator and add coolant if needed.
Remove the radiator cap. Pour
coolant into the radiator up to the
base of the filler neck and into the
reserve tank up to the MAX mark.
Start the engine and let it run until
the radiator cooling fan comes on
at least twice. Then stop the
engine.
Check the level in the windshield
washer reservoir at least monthly
during normal usage. In bad weather,
when you use the washers often,
check the level every time you stop
for fuel.
The windshield washer reservoir is
located behind the passenger’s side
headlight.
12.
13.
14.
15.
16.
CONTINUED
Maintenance
Cooling System, Windshield Washers
Windshield Washers
233
00/12/25 14:31:48 31S0K630_236
To Next Page
Loading...
