Park the vehicle, and set the
parking brake. Locate the release
handle on the rear of the driver’s
door opening, next to the seat.
Pivot this handle towards the
driver’s seat. The rear window will
pop up slightly.
Stand just behind the driver’s door.
Reach under the rear edge of the
rear window at its center and raise
it. It will stay up by itself.
Lift the engine cover.
Pull the support rod out of its clip
and insert the end into the square
hole in the engine cover bracket.
1. 2. 3.
4.
Service Station Procedures
Opening the Engine
Compartment
Before Driving
106
RELEASE HANDLE
ENGINE COVER
SUPPORT RODREAR WINDOW
To Next Page
Loading...
