▲
−
−
＊
＊
Make sure the radio is ON. Insert
the cassette with the open side of the
tape facing right. Push the tape most
of the way into the slot. The system
will pull the tape in the rest of the
way, and begin to play it.
The tape direction indicator will light
to show you which side of the tape is
playing. The indicates the side
youinsertedupwardinnowplaying.
If you want to play the other side,
press the PROG button. When the
player reaches the end of the tape, it
will automatically reverse direction
and play the other side.
Dolby noise reduction turns on
when you insert a tape. If the tape
was not recorded in Dolby, turn it off
by pressing the button. Dolby
remains off until you press the
button again.
If you play a metal or chromium-
dioxide (CrO2) tape, the system
automatically senses it. The METAL
indicator in the frequency display
lights.
To remove the tape, press the
EJECT button. If you want to turn
the player off, press the ON/OFF
button or turn off the ignition. The
tape will remain in the drive. When
youturnthesystembackon,the
tape will begin playing where it left
off.
To switch to the radio while a Tape
is playing, press the AM/FM button.
To rewind the tape,
push the REW (Preset 5) button. To
fast forward the tape, push the FF
(Preset 8) button. Press the PLAY
(Preset 6) button to take the system
outofrewindorfastforward.
Press the SKIP (Preset 4)
button to find the beginning of the
next song or passage.
The system goes into fast forward,
and the light in the SKIP button
flashes during fast forward. When
the system finds the beginning of
thenextsongorpassage,itgoes
back to PLAY.
Dolby noise reduction manufactured under
license from Dolby Laboratories Licensing Corpo-
ration. ‘‘DOLBY’’ and the double-D symbol
are trademarks of Dolby Laboratories
Licensing Corporation.
To Play a Tape
To Stop Playing a Tape
Tape Search Functions
FF/REW
SKIP
Playing a Tape
Comfort and Convenience Features
90
To Next Page
Loading...
Need help?
General
