Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
Put the lens back on the bulb
holder and push it until it latches.
Slide the right side of the light
assembly into the hole. Push on
the left side to latch the assembly
into place.
Turn on the parking lights and
check that the new bulb is
working.
Remove the license light assembly
by carefully prying on the left
edge of the lens with a flat-tip
screwdriver and pulling the
assembly out.
Remove the lens from the bulb
holder by pulling the lens while
squeezing the tabs on both sides
of the holder.
1. 2.
3.
5.
4.
6.
Replacing a Rear License Plate
Bulb
Lights
Maintenance
294
LIGHT ASSEMBLY
BULB HOLDER
BULB
LENS
To Next Page
Loading...
