Place the child seat on the vehicle
seat, then attach the seat to the
lower anchors according to the
child seat maker’s instructions.
Some LATCH-compatible seats
have a rigid-type connector as
shown above.
Other LATCH-compatible seats
have a flexible-type connector as
shown above.
Whatever type you have, follow
the child seat maker’s instructions
for adjusting or tightening the fit.
Attach the tether strap hook to the
tether anchor, then tighten the
strap as instructed by the child
seat maker.
Push and pull the child seat
forward and from side-to-side to
verify that it is secure.
After properly securing the child
seat with the lap/shoulder belt
(see page ), route the tether
strap over the head restraint,
making sure it is not twisted.
4.
5.
6.
7.
8.
21
Installing a Child Seat
48
RIGID TYPE FLEXIBLE TYPE
TETHER STRAP HOOK
ANCHOR
To Next Page
Loading...
