Pull to the side of the road when it is
safe, shift to Park, and let the engine
idle until the indicator goes out.This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. If this indicator comes on at
any other time, there is a problem in
the SH-AWD system. You will also
see a ‘‘CHECK SH-AWD SYSTEM’’
message on the multi-information
display(seepage ).Takeyour
vehicle to a dealer to have it checked.
For more information, see page .
If it comes on while driving, it
indicates the differential
temperature is too high.
You will also see a ‘‘SH-AWD DIFF
TEMP. HIGH’’ message on the
multi-information display (see page
).
If the indicator blinks while driving,
pull to the side of the road when it is
safe, shift to Park, and let the engine
idle until the indicator goes out.
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
You will also see a ‘‘CHECK TIRE
PRESSURE’’ message on the multi-
information display (see page ).
If it comes on while driving, it
indicates that one or more of your
vehicle’s tires are extremely low on
pressure.
If this happens, pull to the side of the
road when it is safe, check which tire
has lost pressure on the multi-
information display, and determine
the cause. If it is because of a flat tire,
have the flat tire repaired as soon as
possible. If two or more tires are
underinflated, call a professional
towing service. For more
information, see page .
Your vehicle has Michelin PAX tires.
Repair or replacement of PAX tires
must be done by an Acura dealer or
an authorized Michelin PAX system
dealer. For more information, see
page .
78
320
78
79
394
421
On models with Michelin PAX system
SH-AWD Indicator
Low Tire Pressure
Indicator
Instrument Panel Indicators
Instruments and Controls
67
Continuing to drive with the SH-AWD
indicator blinking may cause serious
damage to the system.
To Next Page
Loading...
Need help?
General
