▲▼
While the multi-information display
is in the ACC SETUP of the
CUSTOMIZE GROUP, press the
SEL/RESET button. The screen
changes to the above display.
Press the SEL/RESET button. The
screen changes as shown above.
Select ON or OFF by pressing the
INFO ( / ) button, then press the
SEL/RESET button to enter your
selection.
When PRE-RUNNING CAR
DETECT BEEP is set to ON, one
beep sounds when the ACC detects a
vehicle in front of you. You also hear
a beep when that vehicle goes out of
the range of your vehicle’s radar
sensor.
CONTINUED
Multi-Information Display
Pre-Running Car Detect Beep
Instruments and Controls
87
To Next Page
Loading...
